For the new Raspberry Pi Zero, the Zebra Zero Plus Case provides the ultimate protection. After receiving feedback about our first Zebra Zero (type 1) case, we have redesigned the case to earn the title of our flagship Zebra series of cases. The clear top and wood bottom provides clear view of the board while maintaining a low profile thanks to our new C4 nuts. A benefit of our new nuts is that they can accept a screw from wither end so if you installed a HAT or pHAT, it can be secured to the nuts on the other side. A straight or angled GPIO header can be installed on either side of the board. We have also designed this new model to fit a full GPIO cable connector from either side. But perhaps the most standout feature of the Zebra Zero Plus is the built-in breadboard for prototyping your next project.